Shop / gasland tankless water heater propane
Portable Tankless Gas Water Heater for Outdoor Use
Add to wishlist
Category: gasland tankless water heater propane

About this item
- 𝗟𝗘𝗗 𝗗𝗶𝗴𝗶𝘁𝗮𝗹 𝗗𝗶𝘀𝗽𝗹𝗮𝘆 - Bright power the temperature readout so as to not get the water too hot or cold.
- 𝗦𝗮𝗳𝗲𝘁𝘆 𝗜𝗻𝘀𝘁𝗮𝗹𝗹𝗮𝘁𝗶𝗼𝗻 𝗧𝗶𝗽𝘀 - To avoid gas leakage caused by improper sealing of the water heater DO NOT TWINE TEFLON TAPE between the gas regulator and gas inlet pipe. Always check gas leakage before operation.
- **Contents Included**: GASLAND BE158 Tankless Water Heater, CSA-approved gas regulator and 5-foot hose, on/off switch, shower head installation hardware, garden hose connector, and user manual.
- 𝗔𝗱𝘃𝗮𝗻𝗰𝗲𝗱 𝗦𝗮𝘁𝗲𝗳𝘆 𝗣𝗿𝗼𝘁𝗲𝗰𝘁𝗶𝗼𝗻 𝗦𝘆𝘀𝘁𝗲𝗺 - With CSA certification safe as per Canadian and US Standard. Features over-heating protection low water flow protection dry combustion protection anti-freezing protection high water pressure protection and flame failure device.
- 𝟭-𝗬𝗲𝗮𝗿 𝗖𝘂𝘀𝘁𝗼𝗺𝗲𝗿 𝗦𝘂𝗽𝗽𝗼𝗿𝘁 - We provide a 1-year Warranty against manufacture defects and lifetime customer support.
- 𝗚𝗼𝗼𝗱 𝗳𝗼𝗿 𝗢𝗳𝗳-𝘁𝗵𝗲-𝗚𝗿𝗶𝗱 - Runs on a standard 20 lb. liquid propane tank and is equipped with an electronic ignition powered by two D-cell batteries. Can be used in a variety of scenarios: while you're camping RVing hunting hanging poolside washing your pets or horses cleaning your vehicle or even in your tiny home greenhouse or cabin house.
- 𝗠𝗮𝗶𝗻𝘁𝗲𝗻𝗮𝗻𝗰𝗲 𝗧𝗶𝗽𝘀 - Designed for portable outdoor use. It is splash-proof and can manage a little drizzle however prolonged exposure to rain/water will damage the internal components. We recommend using and storing your water heater in a dry place. For the winter please drain out the water by disconnecting the drain plug and storing it in a warm and dry area.
- 𝟭.𝟱𝟴𝗚𝗣𝗠/𝟲𝗟 𝗣𝗿𝗼𝗽𝗮𝗻𝗲 𝗪𝗮𝘁𝗲𝗿 𝗛𝗲𝗮𝘁𝗲𝗿 - Maximum power output 41 000BTU/Hr. The temperature rise is 109.4℉ (43℃) at its highest point and 55.4℉ (13℃) is at its lowest point of 1.58 GPM. Also 1.58 gallons of hot water can be produced per minute at a flow rate of 1.58 GPM. Low water pressure start-up just need 3.6 PSI of water pressure to start.